forumcti.com

Cimatron Technologies Forum
It is currently Fri Sep 10, 2010 4:19 pm

View unanswered posts | View active topics


Board index » Cimatron E » Parting

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 
  Previous topic | Next topic 
Author Message
Phil Brylowski
 Post subject: Backdraft info is not correct
PostPosted: Fri May 09, 2008 10:25 am 
Offline
User avatar

Joined: Fri Feb 01, 2002 11:16 am
Posts: 429
Location: USA
A customer wrote:

<i><font color=blue>I just ran Direction Analysis on a part, and It's flagging a face as backdrafted, when I know it's not. What gives?</i></font id=blue>

The Direction Analysis is dependent on surface normals. If the normal on a face is flipped backward, then the Direction Analysis will be backward as well. Run the Object Direction tool to align the normals on your part, and then you should get good results.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 1 post ] 

Board index » Cimatron E » Parting

All times are UTC - 5 hours [ DST ]

Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group