forumcti.com

Cimatron Technologies Forum
It is currently Mon Sep 01, 2014 9:47 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 1 post ] 
Author Message
 Post subject: Viewing remaining stock
PostPosted: Wed May 04, 2011 9:26 am 
Offline
User avatar

Joined: Fri Feb 01, 2002 11:16 am
Posts: 363
Location: San Jose, CA
A customer wrote:

How accurate is the remaining stock display? I'm expecting to see something around these small .003 rounds after running a cleanup procedure with a .015 cutter.

The remaining stock model is only +/- 0.004, and the stock you are looking for is only about 0.0015. You will see it if you use the Machine Simulator, and adjust the ranges in the deviation tool.

A good way to get an idea of what you are machining, before you get started, is to use the Curvature Map tool. This tool allows you to check the curvature of all inside radii on your part, giving you better information to select the proper tooling to get the job cut correctly.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 5 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group